Telit Modules with Super SIM

Cellular modules covered on this page

• ME901C1

General getting started information

Please refer to the main Knowlegdebase page for modem-independent configuration tips.

ME910C1 Cat-M1, NB-IoT

Initialization

Only configure the modem’s Radio Access Technology (RAT) preference for Cat-M1. To do so, issue AT#WS46=0.

A parameter of 2 instead of 0 indicates both Cat-M1 and NB-IoT. Do not select 1 (NB-IoT only). The default is 0.

Bring up a data connection

1. Set the APN: AT+CGDCONT=1,"IP","super".
2. Activate a PDP context: AT#SGACT=1,1.
   • This will yield the IP address.

Perform a ping

To perform a ping to a remote host after bringing up a connection as described above, issue AT#PING="8.8.8.8". This will yield:

#PING: 01,"8.8.8.8",2,109
#PING: 02,"8.8.8.8",1,109
#PING: 03,"8.8.8.8",1,109
#PING: 04,"8.8.8.8",1,109
OK

Perform an HTTP GET

1. Set the target server: AT#HTTPCFG=0,"jsonplaceholder.typicode.com".
   • 0 is the HTTP “profile ID”.
2. GET a resource: AT#HTTPQRY=0,0,"/todos/1".
   • The first parameter is the profile ID.
   • The second 0 is the command: 0 = GET.
   • The string is the path to the required resource.
3. The modem will issue an outcome URC: #HTTPRING: 0,200,"application/json",83.
   • The first parameter is the profile ID.
     • The second parameter is the HTTP status code.
   • The final parameter is the number of received bytes.
4. Read the data: AT#HTTPRCV=0,0.
   • The first parameter is the profile ID.
   • The second parameter is the number of bytes to read: 0 = all.
5. The modem will return the data:
   

   <<<{ 
      "userId": 1,
      "id": 1,
      "title": "delectus aut autem",
      "completed": false
   }

Data-centric attach mode

To set the ME910C1 to force data-centric attachment, issue AT+CEMODE=2.

The parameter’s value is as follows:

• 0 = PS mode 2: EPS only, data centric
• 1 = CS/PS mode 1: voice centric
• 2 = CS/PS mode 2: data centric
• 3 = PS mode 1: EPS only, voice centric

This setting is non-volatile.

Low-power modes

The ME910C1 supports the eDRX and PSM low-power modes. The commands to enable each of these are:

• eDRX: AT+CEDRXS (see also AT#CEDRXS for “extended eDRX settings”).
• PSM: AT+CPSMS

既知の問題

None at this time.

Additional resources

• ME910C1 Series AT Command Manual
• ME910C1 Datasheet